Semi-automatic permanent magnet slurry iron separator

● Working principle

1. The slurry enters the first-stage tank from the bottom inlet on one side, undergoes iron removal via magnetic rods inside the tank, then flows into the second-stage tank, and successively passes through the third and fourth tanks before being discharged from the outlet, completing the iron removal process.

2. Control the opening and closing of ball valves via the touchscreen, and raise the magnetic system.

3. Manually clean the magnetic impurities from the rods.

4. Lower the magnetic system back into the tank and secure the top cover.

5. Open the inlet and outlet ball valves to begin the next cycle.

 

● Features

1. Permanent magnet iron removal with pneumatic control, significantly saving electrical energy.

2. Sleeveless design allows magnetic rods up to 700 mm in length, with surface magnetic field strength reaching up to 15,000 GS.

3. Easy to operate; combined with PLC control, various parameters can be set according to process requirements for semi-automatic system operation.

4. High material processing capacity, ranging from 8 to 50 m³/h, offering good cost-effectiveness.

 

● Sleeve-type fully automatic liquid pipeline magnetic separator

The self-cleaning pipeline permanent magnetic separator adds an automatic magnetic impurity cleaning system based on the standard pipeline permanent magnetic separator.

 

1. Eliminates manual operation entirely; the entire unit is controlled by a PLC without human intervention.

2. System cleaning time for magnetic impurities is approximately 30 seconds, greatly improving work efficiency.

3. The automatic cleaning type is safer, completely avoiding potential hazards caused by harmful chemicals or high-pressure liquids during operation.

4. Available in dual, triple, or quadruple configurations, with a processing capacity of 8–50 m³/h.

5. Magnetic rod surface field strength up to 15,000 GS; sleeve surface peak field strength ≥12,000 GS; operating temperature range 60–350°C.